Manitowoc Ice Ice Maker K00372 User Manual

K00372 ADAPTER KIT  
Installation Instructions  
The K00372 kit is used for installing Q-1400 or Q-Dual ice machines on a B-970 bin.  
(Refer to Sheet 2 of 3 for pre-installation instructions.)  
1. Note: Bin must be level before installation of ice machine.  
A. Remove the foam tape from the front and sides of the bin where the stainless support/deflector will be located.  
Use the support to reference the areas where the tape should be removed.  
B. Place the support on the front edge of the bin and position as far forward as possible.  
C. Locate the four pieces of the 2” long, 3/4” wide foam tape in the front corners, as shown.  
D. Place the fillers on the bin, as shown. Make sure the two holes from the stainless support/deflector and fillers are  
aligned on the side.  
E. Using the fillers as templates, drill three 5/32” (4 mm.) holes, .500” (12.7 mm.) deep maximum, in the bin.  
Warning: Do not drill through the interior liner. Attach each filler with three 10-24 x .500” screws provided.  
F. Apply foam tape to the front and back of the bin between the fillers. Note: All other required foam tape comes  
preassembled with the stainless support/deflector and fillers.  
G. Note: It is recommended to RTV intersections and along the inside edge of the foam tape to prevent water  
tracking.  
2. Refer to ice machine installation manual for ice machine installation procedures.  
.75” Wide Foam Tape  
Filler  
Filler  
Filler  
.75” Wide Foam Tape  
INSTALLER: It is  
recommended to RTV  
#10-24 x .50”L  
Screws Typ  
intersections and along inside  
edge of foam tape to prevent  
water tracking  
Stainless Steel  
Support/Deflector  
.75” x 2.00”L Foam Tape  
Typ both front corners  
 
8016283  
Sheet 2 of 3  
11/22/04  
Deflector Instructions  
1. Remove the splash shield, water pump, and water trough from the ice machine.  
1. Install the ice deflector, as shown, using two #10-32 mounting screws and tapping plate. Center the ice deflector  
directly beneath the water trough. The ice deflector must be secured with two mounting screws for proper operation  
of the ice machine.  
2. Reassemble the water trough, water pump, and splash shield.  
Water  
Pump  
Splash  
Shield  
Water Trough  
Ice Deflector  
Frame Angle  
#10-32 Mounting Screws  
and Tapping Plate  
 
8016283  
Sheet 3 of 3  
11/22/04  
 

Lennox Hearth Stove EPIC33 User Manual
Life Fitness Treadmill 90T XXXX 01 User Manual
Lincoln Electric Welder IM10064 User Manual
LST Smoke Alarm HT 11006 User Manual
Makita Home Safety Product BML18 User Manual
Marmitek Door PK836 User Manual
Martin Audio Portable Speaker W8LCDI User Manual
Maximatic Slow Cooker MST 800V User Manual
Maxim Music Mixer MAX3420E User Manual
Melissa Microwave Oven 253 001 User Manual