Metra Electronics Electric Heater 95 7953 User Manual

INSTALLATION INSTRUCTIONS FOR PART 95-7953  
APPLICATIONS  
Suzuki Grand Vitara  
2006-2010  
95-7953  
KIT FEATURES  
• Double DIN Radio Provision  
• Stacked ISO Mount Units Provision  
KIT COMPONENTS  
A) Radio Housing • B) Double DIN Brackets • C) Double DIN Trim Plate  
B
C
WIRING AND ANTENNA CONNECTIONS (Sold Separately)  
Wiring Harness:  
A
• 70-1721 - Honda/Acura harness 1998-up  
Antenna Adapter:  
• Not required  
TOOLS REQUIRED:  
Small Flat Blade Screwdriver • Panel Removal Tool  
• Phillips Screwdriver • Socket Set  
1-800-221-0932  
© COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION  
 
95-7953 DASH DISASSEMBLY  
SUZUKI GRAND VITARA 2006-2010  
*Note: Refer also to the instructions included with the aftermarket radio.  
A
1
Disconnect the negative battery-  
terminal to prevent an accidental  
short circuit.  
2
3
Unclip and remove the (2) outside  
trim panels. (Figure A)  
Remove (6) Phillips screws secur-  
ing the radio and climate controls  
to the sub dash. Unplug and  
remove radio/climate control  
assembly. (Figure B)  
4
5
Remove the (2) Phillips screws  
securing the factory radio bracket  
to the radio/climate control  
assembly. (Figure C)  
B
Separate the bracket and factory  
radio from the climate control.  
(Figure D)  
Continue to kit assembly.  
C
D
1
 
95-7953 KIT ASSEMBLY  
DOUBLE DIN RADIO PROVISION  
*Note: Refer also to the instructions included with the aftermarket radio.  
NOTE: Mount the radio housing to the climate control assembly using the factory  
screws removed in step 4 of dash disassembly.  
1
2
Snap the Double DIN brackets to the  
inside edge of the Double DIN trim  
plate. (Figure A)  
A
Slide the Double DIN radio into the  
bracket/trim plate assembly and  
secure the radio to the assembly  
using the screws supplied with the  
radio. (Figure B)  
3
Snap the Double DIN trim plate onto  
the front of the housing/radio  
assembly. (Figure B)  
Continue to final assembly.  
B
2
 
95-7953 KIT ASSEMBLY  
STACKED ISO MOUNT UNITS PROVISION  
*Note: Refer also to the instructions included with the aftermarket radio.  
NOTE: Mount the radio housing to the climate control assembly using the factory  
screws removed in step 4 of dash disassembly.  
1
2
Snap the Double DIN brackets to the  
inside edge of the Double DIN trim  
plate. (Figure A)  
A
Slide the stacked ISO units into the  
bracket/radio housing assembly and  
secure the units to the kit using the  
screws supplied with the units.  
(Figure B)  
3
Snap the Double DIN trim plate onto  
the front of the housing/radio  
assembly. (Figure B)  
B
Continue to final assembly.  
3
 
95-7953 FINAL ASSEMBLY  
FINAL ASSEMBLY  
A
B
(A) Strip wire ends back 1/2"  
B) Twist ends together  
C) Solder  
D) Tape  
C
D
Locate the factory wiring harness in the dash. Metra recommends using the  
proper mating adapter and making connections as shown. (Isolate and individ-  
ually tape off the ends of any unused wires to prevent electrical short circuit.)  
1
2
3
Re-connect the negative battery terminal and test the unit for proper operation.  
Reassemble radio and dash assemblies in reverse order of disassembly.  
FINAL WIRING CONNECTIONS  
Make wiring connections using the EIA color code chart shown below and the instructions included with the  
head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and  
individually tape off ends of any unused wires to prevent electrical short circuit.  
METRA / EIA WIRING CODE  
12V Ignition / Acc. . . . . . . . . . Red  
Right Front (+) . . . . . . . . . . . . Gray  
12V Batt / Memory. . . . . . . . . Yellow  
Ground. . . . . . . . . . . . . . . . . . Black*  
Power Antenna. . . . . . . . . . . . Blue  
Right Front (-). . . . . . . . . . . . . Gray/ Black  
Left Front (+) . . . . . . . . . . . . . White  
Left Front (-). . . . . . . . . . . . . . White / Black  
Right Rear (+) . . . . . . . . . . . . Violet  
Amp Turn-On . . . . . . . . . . . . . Blue / White  
Amp Ground. . . . . . . . . . . . . . Black / White  
Illumination . . . . . . . . . . . . . . Orange  
Dimmer . . . . . . . . . . . . . . . . . Orange / White  
Right Rear (-) . . . . . . . . . . . . . Violet / Black  
Left Rear (+) . . . . . . . . . . . . . Green  
Left Rear (-) . . . . . . . . . . . . . . Green / Black  
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.  
All colors may not be present on all leads due to manufacturer’s specifications.  
4
 
95-7953  
NOTES  
5
 
95-7953 INSTRUCTIONS  
1-800-221-0932  
REV. 04/26/10 © COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION INST95-8211  
 

Lennox Hearth Gas Grill H3541 CUGK35C 35 CHARCOAL User Manual
Lightolier Indoor Furnishings VRA2G18LP332 User Manual
Lincoln Electric Welder 2HBG User Manual
Linksys Digital Camera WVC54G UK User Manual
Listen Technologies Power Supply LA 205 User Manual
Lowrance electronic Fish Finder HDS 5 User Manual
Magnasonic Clock Radio CRD1180M User Manual
Martin Audio Portable Speaker S18+ User Manual
Maxtor DVR 4Channel Stand alone DVMR User Manual
Meade Telescope 90AZ ADRB User Manual