Uniden Cordless Telephone DSS5805 User Manual

 
Install the Battery Pack  
Charge the battery pack for at least 15-20 hours before  
completing the installation or using the handset.  
Press down on the battery cover  
release and slide the cover down until  
it comes off.  
1
Connect the battery pack connector  
2
observing the correct polarity (black  
and red wires) to the jack inside the  
battery compartment.  
Do not exert any force on this connection.  
It could cause damage to the battery or to  
the handset. The plastic connectors will fit  
in only one way.  
Once you are certain that you have made a  
good connection, then insert the battery  
pack into the battery compartment. Do  
not pinch the wires.  
Securely close the battery  
compartment cover by sliding it  
until it snaps into place.  
3
Place the handset in the charging  
cradle with the keypad facing forward.  
4
Use only the Uniden battery (BT-446)  
supplied with your phone. Replacement  
batteries are also available through the  
Service Division (See page 1).  
Recharge your handset on a regular basis  
by returning the handset to the charger  
after each phone call.  
Battery Information  
Battery use time (per charge)  
From fully charged (15-20 hours charge time)  
Up to 4 hours continuous use  
Up to 8 days when the handset is in the standby mode  
– 2 –  
 
Low battery alert  
When the battery pack is very low and needs to be charged, the  
phone is programmed to eliminate functions in order to save power.  
If the phone is in the standby mode, Low Batteryappears  
on the LCD and none of the keys will operate. If the phone is in  
use, Low Batteryappears and the handset beeps. Complete  
your conversation as quickly as possible and return the handset to  
the base unit for charging.  
Cleaning the battery charging contacts  
To maintain a good charge, it is important to  
clean the charging contacts on both the  
handset and base unit once a month. Use  
a dry cloth or pencil eraser to clean.  
contacts  
Connect the Charger  
Connect the AC adapter  
1
to the DC IN 9V jack and  
to a standard wall outlet.  
Set the charger on a desk  
2
or tabletop, and place  
the handset in the  
charger with the keypad  
facing forward.  
Make sure that the  
charge LED illuminates.  
3
If the LED does not illuminate, check to see that the AC adapter  
is plugged in and that the handset makes good contact with the  
base charging contacts.  
Use only the supplied AAD-600S  
AC adapter. Do not use any  
other AC adapter.  
Polarity of the plug  
Place the charger close to the AC  
outlet so that you can unplug the  
AC adapter easily.  
• ”HS2appears on the display  
while the handset is charging.  
– 3 –  
 
Register the Handset  
You need to register the DSS5805 before use.  
To register the additional handset, place the DSS5805 handset on  
the original units base (DSS5855) for at least 5 seconds. The status  
LED on the original base will flash indicating that registration is  
occurring. After 5 seconds, the DSS5805 handset will be registered.  
In some cases you may need to attempt registration  
a few times.  
You cannot register the handset when the original phone  
is in use.  
Call Transfer Feature  
You can transfer an outside call to the original unit. For more  
instructions, see the owners manual supplied with the original unit.  
To transfer a call to the  
original unit  
Press xfer/del during a call.  
When the original unit receives the  
transferred call, the DSS5805 handset  
returns to the standby mode.  
To receive a transferred call  
from the original unit  
Press talk/flash or spkr to answer  
the transferred call.  
To cancel the transfer  
Press talk/flash or spkr.  
If you transfer a call and it is not picked up after 5 minutes,  
you hear a beep, and the call will be disconnected.  
Only one handset at a time can talk with an outside caller.  
The earcap of this telephone may attract and retain small  
metallic objects.  
– 4 –  
 
Notes  
– 5 –  
 
WARRANTY  
One Year Limited Warranty  
Important:  
Warrantor:  
Evidence of original purchase is required for warranty service.  
Uniden Australia Pty Limited A.B.N. 58 001 865 498  
ELEMENT OF WARRANTY: Uniden warrants to the original retail owner for the duration of  
this warranty, its DSS5805 (herein after referred to as the Product), to be free from defects  
in materials and craftsmanship with only the limitations or exclusions set out below.  
WARRANTY DURATION: This warranty to the original retail owner only, shall terminate and  
be of no further effect 12 months after the date of original retail sale. This warranty will be  
deemed invalid if the product is; (A) Damaged or not maintained as reasonable and  
necessary, (B) Modified, altered or used as part of any conversion kits, subassemblies, or any  
configurations not sold by Uniden, (C) Improperly installed, (D) Repaired by someone other  
than an authorised Uniden Repair Agent for a defect or malfunction covered by this  
warranty, (E) Used in conjunction with any equipment or parts or as part of a system not  
manufactured by Uniden, (F) Warranty is only valid in original country of purchase.  
PARTS COVERED: This warranty covers for one (1) year, the Base Unit and Handset only. All  
accessories (AC Adaptor etc)are covered for 90 days only.  
STATEMENT OF REMEDY: In the event that the product does not conform to this warranty at  
any time while this warranty is in effect, the warrantor at its discretion, will repair the  
defect or replace the product and return it to you without charge for parts or service. THIS  
WARRANTY DOES NOT COVER OR PROVIDE FOR THE REIMBURSEMENT OR PAYMENT OF  
INCIDENTAL OR CONSEQUENTIAL DAMAGES. THIS GUARANTEE IS IN ADDITION TO AND DOES  
NOT IN ANY WAY AFFECT YOUR RIGHTS UNDER THE CONSUMER GUARANTEE ACT.  
PROCEDURE FOR OBTAINING PERFORMANCE OR WARRANTY: In the event that the product  
does not conform to this warranty, the Product should be shipped or delivered, freight  
pre-paid, with evidence of original purchase (eg. a copy of the sales docket), to the  
warrantor at:  
UNIDEN AUSTRALIA PTY LIMITED  
SERVICE DIVISION  
UNIDEN NEW ZEALAND LIMITED  
SERVICE DIVISION  
345 Princes Highway, Rockdale NSW 2216  
Ph (02) 9599 3355 Fx (02) 9599 3278  
Toll Free 1300 366 895  
150 Harris Road, East Tamaki, Auckland  
Ph (09) 273 8383 Fx (09) 274 4253  
Toll Free 0800 4 UNIDEN (4 864 336)  
Customers in other States should ship or deliver the Product freight pre-paid to their nearest  
Uniden Authorised Repair Centre (Contact Uniden for the nearest Warranty Agent to you).  
– 6 –  
 
 

TDK Network Card GSM DCS PCS Tx User Manual
Thermador Oven C271 User Manual
Thule Automobile Accessories 018 User Manual
Toshiba Power Supply 1500 SERIES User Manual
TRENDnet Network Hardware TEW640MB User Manual
Tripp Lite Power Supply UT1250UL User Manual
Tripp Lite TV Cables S236 000 User Manual
Tunturi Exercise Bike C20 User Manual
United States Stove Patio Heater 6041 User Manual
Vestax Music Mixer VOM QFO LE DX User Manual