Installation Guide SMT 2200/3000 VA
Input/Output Hardwire Kit
Safety
Adhere to all national and local electrical codes. A certified electrician must perform all electrical
connections.
1. Disconnect equipment connected to the UPS.
2. Press the OFF button located on the front of the UPS.
3. Disconnect the batteries in the UPS.
4. Disconnect the UPS from utility power.
NOTE: When removing the panels from the UPS, note which cable is connected to the AC input. There are two
4-pin connectors on the UPS and they are not interchangeable.
Inventory
Note: The illustrations in this document may differ slightly from the actual hardware.
Terminal block
4 grounding screws
8 screws
secure input, output, and
blank panels to the UPS
2 wire nuts
Terminal block label
2 screws secure the
terminal block to the UPS
Input panel
Output panel
Blank panel
|