Bogen Amplified Phone ASM1 User Manual

®
Easy Install  
Amplified Speaker  
Model ASM1  
Speaker Layout  
The layout of the speakers should be planned before installation  
begins. Layout starts in one corner of the room. The first speaker  
should be positioned from each wall a distance approximately equal  
to the ceiling height of the room.  
The next speaker in row 1 should be spaced a distance approxi-  
mately equal to twice the height of the ceiling. Each additional speak-  
er in the row should use this same spacing.  
Row 2 starts at twice the ceiling height distance from row 1 and  
twice the ceiling height from the wall.The other speakers in this row  
are also spaced at twice the ceiling height.  
Row 3 is again spaced at twice the ceiling height from the previous  
row.The first speaker starting this row is positioned at one ceiling  
height distance from the wall (similar to row 1).  
Continue this pattern of alternating rows until the room is covered.  
Because of the wide sound dispersion characteristic of the ASM1,  
exact placement is not critical. The spacing of the speakers can be  
adjusted so that the speakers are evenly spaced in a row.  
Speaker Installation  
STEP 1 - Position the speaker on the ceiling tile and slowly push the  
speaker, forcing the studs through the ceiling tile.  
STEP 2 - Clean any loose debris or conductive foil from around the  
studs. Spin the wide-based wing nuts (supplied) down the  
threaded studs.Tighten the wing nuts until they are very  
snug (finger tighten only - no tools required). Check that  
the speaker is drawn tight to the ceiling tile. Fiberglass  
sleeves (supplied) should be placed over the studs at this  
point to insulate the exposed portion of the studs as a  
safety precaution.  
Step 3  
Step 2  
STEP 3 - The electrical connections are made to the studs with the  
wire nuts (supplied).The studs are color-coded to indicate  
polarity.  
Step 1  
Amplifier connections are:  
Threaded COPPER stud – Audio Signal (+)  
Threaded NICKEL stud – Audio Signal (-)  
Smooth COPPER stud – 24V DC (+)  
Smooth NICKEL stud – 24V DC (-)  
Audio  
Signal (–)  
Audio  
Signal (+)  
24V DC (–) 24V DC (+)  
Nylon wire ties (supplied) can be used to secure the speaker wires  
to the studs if desired.(Nylon wire ties should wrap around the fiber-  
glass sleeve.)  
Volume Knob  
Set volume to maximum (1) before  
installation and adjust as needed  
54-2159-01A 0611  
© 2006 Bogen Communications Inc. All rights reserved.  
Specifications subject to change without notice.  
 

Blackberry Cell Phone SWD 1590032 0505111339 001 User Manual
Blodgett Freezer 30036SB User Manual
Blue Rhino Outdoor Fireplace WAF607A User Manual
Braun Electric Shaver 360s 4 User Manual
Briggs Stratton Lawn Mower GT23540 User Manual
Britax Baby Carrier LATCHANCHOR User Manual
Broan Ventilation Hood QTR140 User Manual
Casio Cell Phone C721 User Manual
Casio Musical Toy Instrument MZ x300 User Manual
Chamberlain Home Security System 955D User Manual