P/NO : 3828TUO197A (0203-Rev00)
Printed in Korea
Contents
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .A1
Important Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .A2
Description of Controls . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .A4
Connecting the Monitor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .A6
Connection of external equipment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .A8
On Screen Display (OSD) Control Adjustment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .A9
On Screen Display(OSD) Selection and Adjustment . . . . . . . . . . . . . . . . . . . . . . . . . . . .A10
Video Memory Modes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .A14
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .A15
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .A16
i
Introduction
The FPD2200 Flat Panel Monitor has an active matrix TFT (Thin-Film
Transistor) LCD (Liquid Crystal Display).
Features
The FPD2200 is a 22-inch (55.8cm viewable) intelligent micro-processor based
monitor.
This monitor can be connected to a VCR or DVD. The monitor has two signal
connectors (D-sub and DVI-D) so that it can support both an existing analog
input (D-sub) and an advanced standard digital input (DVI-D). Two computers
can be simultaneously used while connected to this monitor.
This monitor has a picture-in-picture function so that you can watch from
VCR/DVD while using a computer.
The aspect ratio of the monitor is 16:10 so that you can feel as if you are
watching a film in a theater. You can also simultaneously display two pages of a
document set to an A4 size on the monitor, so that working efficiency can be
improved.
Digitally controlled auto-scanning is done with the micro-processor for horizontal
scan frequencies between 30 and 70kHz, and vertical scan frequencies
between 56 - 61Hz.
We accomplished to adapt the advanced design and technology to the monitor.
Soft touch buttons on the front panel are simple and allow you to conveniently
adjust a variety of image controls.
This monitor has DDC 2B function.
A1
Important Precautions
This unit has been engineered and manufactured to ensure your personal
safety, however improper use may result in potential e shock or fire hazards.
In order to allow the proper operation of all safeguards incorporated in this
display, observe the following basic rules for its installation, use, and
servicing.
On Safety
Use only the power cord supplied with the unit. In case you use another power
cord, make sure that it is certified by the applicable national standards if not being
provided by the supplier. If the power cable is faulty in any way, please contact the
manufacturer or the nearest authorized repair service provider for a replacement.
The power supply cord is used as the main disconnection device. Ensure that the
socket-outlet is easily accessible after installation.
Operate the display only from a power source indicated in the specifications of
this manual or listed on the display. If you are not sure what type of power supply
you have in your home, consult with your dealer.
Overloaded AC outlets and extension cords are dangerous. So are frayed power
cords and broken plugs. They may result in a shock or fire hazard. Call your service
technician for replacement.
Do not Open the Display.
There are no user serviceable components inside.
There are Dangerous High Voltages inside, even when the power is OFF.
Contact your dealer if the display is not operating properly.
To Avoid Personal Injury :
Do not place the display on a sloping shelf unless properly secured.
Use only a stand recommended by the manufacturer.
Do not try to roll a stand with small casters across thresholds or deep pile
carpets.
To Prevent Fire or Hazards:
Always turn the display OFF if you leave the room for more than a short period
of time. Never leave the display ON when leaving the house.
Keep children from dropping or pushing objects into the display's cabinet
openings. Some internal parts carry hazardous voltages.
Do not add accessories that have not been designed for this display.
During a lightning storm or when the display is to be left unattended for an
extended period of time, unplug it from the wall outlet.
A2
Important Precautions
On Installation
Do not allow anything to rest upon or roll over the power cord, and do not place
the display where the power cord is subject to damage.
Do not use this display near water such as near a bathtub, washbowl, kitchen
sink, laundry tub, in a wet basement, or near a swimming pool.
Displays are provided with ventilation openings in the cabinet to allow the release
of heat generated during operation. If these openings are blocked, built-up heat
can cause failures which may result in a fire hazard. Therefore, NEVER:
Block the bottom ventilation slots by placing the display on a bed, sofa, rug, etc.
Place the display in a built-in enclosure unless proper ventilation is provided.
Cover the openings with cloth or other material.
Place the display near or over a radiator or heat source.
Do not rub or strike the Active Matrix LCD with anything hard as this may scratch,
mar, or damage the Active Matrix LCD permanently.
Do not press the LCD screen with your finger for a long time as this may cause
some afterimages.
Some dot defects may appear as Red, Green or Blue spots on the screen.
However, this will have no impact or effect on the display performance.
If possible, use the recommended resolution to obtain the best image quality for
your LCD display. If used under any mode except the recommended resolution,
some scaled or processed images may appear on the screen. However, this is
characteristic of the fixed-resolution LCD panel.
On Cleaning
Unplug the display before cleaning the face of the display screen.
Use a slightly damp (not wet) cloth. Do not use an aerosol directly on the display
screen because over-spraying may cause electrical shock.
On Repacking
Do not throw away the carton and packing materials. They make an ideal
container in which to transport the unit. When shipping the unit to another
location, repack it in its original material.
A3
Description of Controls
Front Panel Controls
SET Button
Power Button
MENU Button
SOURCE
MENU
DOWN/UP
LEFT/RIGHT
SET
SOURCE Selection
Button
LEFT/RIGHT (
Buttons
)
DOWN/UP (
Buttons
)
Power Indicator
Control
Function
Use this button to select an input signal.
SOURCE
SOURCE Selection
Button
SOURCE
DOWN/UP
SET
INPUT SELECT
DVI DIGITAL
• DVI DIGITAL : DVI digital signal
• DSUB ANALOG : 15-pin D-sub analog signal
• V1(AV): Composite video
DSUB
ANALOG
V1 (AV)
(S)
V2
• V2(S): S video
MENU
MENU Button
Use this button to enter or exit the On Screen Display.
Use these buttons to choose or adjust items in the
On Screen Display.
DOWN/UP (
Buttons
)
DOWN/UP
LEFT/RIGHT
SET
Use these buttons to choose or adjust items in the
On Screen Display.
LEFT/RIGHT (
Buttons
)
SET Button
Use this button to enter a selection in the On
Screen Display.
Power Indicator
This indicator lights up green when the monitor
operates normally. If the monitor is in DPM (Energy
Saving) mode (stand-by/ suspend/power off), this
indicator color changes to amber.
Power Button
Use this button to turn the monitor on or off.
A4
|