Estate Clothes Dryer EGD4300T User Manual

Gas Dryer  
PRODUCT MODEL NUMBERS  
OVERALL DIMENSIONS  
EGD4300T  
EGD4300V  
EGD4400V  
Gas supply: Dryer is equipped for use with  
Natural gas. Dryer can be converted to L.P. gas.  
When rigid pipe is used it should be 1/2" IPS.  
When acceptable to the gas supplier and local  
codes, 3/8" approved aluminum or copper tubing  
may be used for lengths under 20 feet (6.1 m). For  
lengths over 20 feet (6.1 m), larger tubing should  
be used. Pipe-joint compounds resistant to the  
action of L.P. gas must be used. If local codes  
permit, it is recommended that new flexible metal  
tubing, design-certified by CSA, be used for  
connecting the appliance to the rigid gas supply  
line. (The gas pipe which extends through the  
lower rear of the appliance has 3/8" male pipe  
thread.) An individual manual shutoff valve must  
be installed within 6 feet (1.8 m) of the dryer in  
accordance with the National Fuel Gas Code ANSI  
Z223.1.  
A
B
A. Small Opening  
Side-Swing Door  
B. Large Opening  
Side-Swing Door  
C
Electrical: A 120 volt, 60 Hz, AC only, fused  
electrical supply is required on a separate 15- or  
20- amp circuit. A time-delay fuse or circuit  
breaker is recommended.  
D
C. Wide Opening  
Side-Swing Door  
D. Wide Opening  
Hamper Door  
Exhaust venting: Exhaust your dryer to the  
outside. 4" (10.2 cm) vent is required. Rigid or  
flexible metal exhaust vent must be used. Do Not  
use plastic or metal foil vent. Exhaust outlet hood  
must be at least 12" (30.5 cm) from the ground or  
any object that may be in the path of the exhaust.  
RECESSED AREA AND CLOSET INSTALLATION  
For closet installation  
with a door, minimum  
ventilation openings in  
the top and bottom of  
the door are required.  
Louvered doors with  
equivalent ventilation  
openings are acceptable.  
A
B
C
A. Recessed area  
B. Side view - closet or confined area  
C. Closet door with vents  
EXHAUST VENTING  
4"  
(10.2 cm)  
Box hood style  
1. Select the route that will provide the straightest and most direct path outdoors. Plan  
the installation to use the fewest number of elbows and turns. When using elbows or  
making turns, allow as much room as possible. Bend vent gradually to avoid kinking.  
Avoid 90° turns.  
4"  
(10.2 cm)  
2.5"  
4"  
(6.4 cm)  
(10.2 cm)  
Vent Length Chart  
2. Determine vent length.  
Number of  
90° turns  
or elbows  
Type of  
vent  
Box or  
Louvered  
hoods  
Angled  
hoods  
The maximum length of the exhaust system depends upon:  
• The type of vent (rigid metal or flexible metal).  
• The number of elbows used.  
• Type of hood.  
See the exhaust vent length chart that matches your hood type for the maximum vent  
lengths you can use.  
3. Determine the number of elbows you will need.  
IMPORTANT: Do not use vent runs longer than specified in the Vent Length Chart.  
0
1
2
3
4
Rigid metal  
Flexible metal 36 ft (11 m)  
64 ft (20 m)  
58 ft (17.7 m)  
28 ft (8.5 m)  
Rigid metal  
Flexible metal  
54 ft (16.5 m)  
31 ft (9.4 m)  
48 ft (14.6 m)  
23 ft (7 m)  
Rigid metal  
Flexible metal 27 ft (8.2 m)  
44 ft (13.4 m) 38 ft (11.6 m)  
19 ft (5.8 m)  
Rigid metal  
Flexible metal 25 ft (7.6 m)  
35 ft (10.7 m) 29 ft (8.8 m)  
17 ft (5.2 m)  
In the column listing the type of metal vent you are using (rigid metal or flexible metal),  
find the maximum length of metal vent on the same line as the number of elbows.  
Rigid metal  
Flexible metal 23 ft (7 m)  
27 ft (8.2 m)  
21 ft (6.4 m)  
15 ft (4.6 m)  
Because Whirlpool Corporation policy includes a continuous commitment to improve  
our products, we reserve the right to change materials and specifications without notice.  
Dimensions are for planning purposes only. For complete details, see Installation  
Instructions packed with product. Specifications subject to change without notice.  
Ref. W10150630A  
4-15-08  
 

Echo Trimmer PAS 2601 User Manual
Electrolux Oven EOK86030 User Manual
Faber Ventilation Hood Island Mount Canopy Rangehood User Manual
Fisher Price Baby Toy T7164 User Manual
Fisher Price Doll B1512 User Manual
Fujitsu Printer FTP628 MCL383 User Manual
Furman Sound Musical Instrument HDS 16 User Manual
GE Dishwasher GDWF100 User Manual
GE Dishwasher PDWT500 580R User Manual
Giant Septic System MP4130HTC User Manual