Gamber Johnson Laptop Docking Station 7160 0486 User Manual

INSTALLATION INSTRUCTIONS  
Product  
7160-0486, 7160-0487  
Revision  
Form  
INST-596  
Rev .B  
Printing Spec: PS-001  
FZ-G1 DOCKING STATION  
This instruction sheet is for the FZ-G1 docking station only. For instructions on  
features, set-up, and operation of the FZ-G1 computer, please refer to the  
manual provided by Panasonic with the computer.  
This docking station is designed to be used with a variety of Gamber-Johnson  
mounting systems. Installation instructions for other Gamber-Johnson products  
are provided with each individual product.  
This instruction sheet is for the following products:  
Item No. 7160-0486-00(-P)(-E) Keyed alike, No RF  
Item No. 7160-0486-02(-P)(-E) Keyed alike, Dual RF  
Item No. 7160-0486-03(-P)(-E) Keyed different, No RF  
Item No. 7160-0486-04(-P)(-E) Keyed different, Dual RF  
Item No. 7160-0487-00(-P)(-E) Keyed alike, No RF  
Item No. 7160-0487-02(-P)(-E) Keyed alike, Dual RF  
Item No. 7160-0487-03(-P)(-E) Keyed different, No RF  
Item No. 7160-0487-04(-P)(-E) Keyed different, Dual RF  
Product Mounting Disclaimer  
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage  
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson  
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is  
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications  
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.  
© Copyright 2012 Gamber-Johnson, LLC  
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868  
 
FZ-G1 DOCKING STATION FEATURE IDENTIFICATON  
Button Latch  
Top Hooks  
Slide Plate  
(Keyed alike,  
or Keyed different)  
Base  
Guide Block  
(Can be removed for  
use with FZ-G1 that has  
an extended battery or  
card slot attachment)  
Alignment Tabs  
Dual RF Output  
Docking Connector  
Dual RF Connector  
Ground Pins  
Cable Tie Openings  
Serial  
Video  
RF Switch - move to  
outside position for  
External RF Antenna  
4X Mounting Studs  
(1/4-20unc for model 7160-0486)  
(M6-1.0 for model 7160-0487)  
15.6 Vdc Input  
Ethernet  
(2) USB  
HDMI - If using HDMI cable, snap  
ferrite (GJ# 15064 - Fair-Rite Part #  
0431167281) supplied in the hardware  
bag onto the HDMI cable as close to  
the dock as possible  
 
DOCKING AND UNDOCKING THE COMPUTER  
Figure 1  
1. Turn the computer off.  
Vertical Walls  
Guide Block  
2. With the slide plate in the open  
position, insert the bottom of the  
computer into the docking station.  
Make sure the guide tabs are lined up  
with the pockets on the back side of  
the computer.  
Guide tabs  
Rotate the top of the comptuter under  
the top hooks until the computer is  
resting on the two vertical walls sticking  
out from the slide plate.  
Figure 2  
(see Figues 1, 2 & 3)  
(Note: If your FZ-G1 computer has an  
extended battery or card slot  
attachment on the back side, you will  
need to remove the guide block from  
the face of the dock before inserting  
the computer.)  
3. Push downward on the slide plate  
to latch the dock. (See Figure 4)  
4. (Optional) The key lock can now  
be used for security purposes.  
Figure 3  
TO UNDOCK THE COMPUTER  
1. Turn the computer off.  
2. Unlock if locked.  
Figure 4  
3. Press the Latch Button. The slide  
plate is spring loaded and should raise  
with your hand when you release the  
button.  
4. Rotate the top of the computer out  
of the dock to remove.  
 
Regulatory Certification Information  
Regulatory Model #: 7160-0486  
GJ Model #'s: 7160-0486-00, 7160-0486-02, 7160-0486-03, 7160-0486-04  
7160-0486-00-P, 7160-0486-02-P, 7160-0486-03-P, 7160-0486-04-P  
7160-0487-00, 7160-0487-02, 7160-0487-03, 7160-0487-04  
7160-0487-00-E, 7160-0487-02-E, 7160-0487-03-E, 7160-0487-04-E  
Descriptions: Dock-Panasonic-FZG1  
Certifications:  
EN 55022:2010 CISPR 22:2008 Class B  
EN 50498:2010  
EN 50581:2012  
IEC 60950-1:/A1:2009  
EN 60950-1/A12:2011  
CAN/CSA C22.2 No. 60950-1/A1:2011  
UL 60950-1/R:2011-12  
E-Mark  
This device complies with Part 15 of the FCC Rules. Operation is subject to  
the following two conditions. (1) this device may not cause harmful  
interference, and (2) this device must accept any interference received,  
including interfernece that may cause undesired operation.  
10R-04 7045  
Gamber-Johnson LLC, 3001 Borham Ave.,  
Stevens Point, WI, 54481, USA, 715-344-3482  
 

Eizo Computer Monitor L461 User Manual
Euro Pro Convection Oven TO36 User Manual
Fisher Paykel Cooktop OR90SBDSIX User Manual
Fisher Price Crib Toy N1128N1128 User Manual
Fujitsu Network Router AP 500RP User Manual
Furuno Musical Table rd30 User Manual
Furuno Telephone FM 8800S User Manual
Gardena Trimmer RL 10 User Manual
GE Air Conditioner AGE07 User Manual
GE Washer Dryer DBXR453ET User Manual