Gateway Computer Hardware AMI 493 User Manual

Update...  
AMI 493 RAID controller firmware  
update and drive installation  
If you add a new hard drive to an existing array that has an  
AMI 493 controller (firmware version B147 or older), the  
Power Console Plus software will scan the drive in a  
continuous loop.  
To remedy this situation, do one of the following:  
Use the interim solution to install a new drive, perform  
a migration, or create a new array.  
- OR -  
Update the controller firmware to version B148 or greater.  
The firmware update is located on the technical support  
Important  
If the firmware is not available, perform the interim solution.  
Interim solution:  
1 Turn off the server.  
2 Install the new hard drive.  
3 Turn on the server.  
4 During the server startup procedure, press CTRL+H to open  
the WebBIOS utility and perform the RAID migration or  
create another array for the new drive.  
5 When done, exit WebBIOS, then reboot the server.  
 

Electro Voice Speaker System HP66 User Manual
ETA Systems Power Supply PD9L User Manual
Everpure Water System WS 30 User Manual
Fisher Price Crib J6982 User Manual
Fisher Price Satellite Radio P6584 User Manual
Frigidaire Range 316135921 User Manual
Fundex Games Games Shoot the Moon User Manual
GE Air Conditioner ASV18DK User Manual
GE Clothes Dryer DBXR453 User Manual
GE Washer GBVH6260 User Manual