Harbor Freight Tools Home Safety Product 92061 User Manual

Camping Flashlight  
92061  
ASSEMBLY AND OPERATING INSTRUCTIONS  
3491 Mission Oaks Blvd., Camarillo, CA 93011  
Copyright © 2004 by Harbor Freight Flashlights®. All rights reserved. No portion of  
this manual or any artwork contained herein may be reproduced in any shape or form  
without the express written consent of Harbor Freight Flashlights.  
For technical questions and replacement parts, please call 1-800-444-3353  
 
6. Maintain flashlights with care. Keep flashlights maintained and clean for  
better and safer performance. Follow instructions for maintenance and  
changing accessories.The handles must be kept clean, dry, and free from oil  
and grease at all times.  
7. Disconnect power.Turn off flashlight when not in use. Remove batteries if  
flashlight is not going to be used for a long period of time.  
8. Avoid unintentional starting. Be sure the switch is in the Off position when  
not in use and before replacing batteries.  
9. Stay alert. Watch what you are doing, use common sense. Do not operate  
any flashlight when you are tired.  
10. Check for damaged parts. Before using any flashlight, any part that appears  
damaged should be carefully checked to determine that it will operate properly  
and perform its intended function. Check for any condition that may affect  
proper operation.Any part that is damaged should be properly repaired or  
replaced by a qualified technician. Do not use the flashlight if the switch does  
not turn On and Off properly.  
11. Guard against electric shock. Prevent body contact with grounded surfaces  
such as pipes, radiators, ranges, and refrigerator enclosures.  
12. Do not use camping equipment if under the influence of alcohol or  
drugs. Read warning labels on prescriptions to determine if your judgment or  
reflexes are impaired while taking drugs. If there is any doubt, do not use this  
product or other camping appliances.  
13. Maintenance. For your safety, service and maintenance should be performed  
regularly by a qualified technician.To maintain water resistance, be sure that  
all rubber seals are not damaged and properly installed.  
14. The compass contains mineral oil, which can be harmful if ingested.  
Discard the flashlight if leaking or otherwise damaged, and rinse any areas  
that come into contact with the oil thoroughly.  
NOTE: This flashlight is water resistant, but not water proof.When properly as-  
sembled and maintained, you may use it with confidence in rain or damp condi-  
tions. However, if it is totally immersed in water if is likely to be damaged.  
Warning: The warnings, cautions, and instructions discussed in this instruc-  
tion manual cannot cover all possible conditions and situations that may oc-  
SKU 92061 DowFnlooardtferocmhWniwcwa.lSqomuaensutailos.ncosm,.pAllel MaasneuaclsaSlle1a-rc8h0A0n-d44D4ow-3nl3o5ad3. Page 3  
cur. It must be understood by the operator that common sense and caution are  
factors which cannot be built into this product, but must be supplied by the  
operator.  
Unpacking  
When unpacking, check to make sure the following parts are included.  
Flashlight  
4 filters stored in the filter compartment  
Spare Krypton bulb, stored in the spare bulb compartment  
If any parts are missing or broken, please call Harbor Freight Flashlights at the  
number on the cover of this manual.  
NOTE: Warranty replacement parts or accessories specific to this flashlight are not  
available from Harbor FreightTools for this item.Replacement batteries and light  
bulbs may be available at your local Harbor Freight Tools retail outlet, or are  
commonly available from hardware and department stores.  
Operation  
First install two (2) “AA” batteries (not included).  
1. Remove the battery compartment cap, located at the bottom of the flashlight,  
by turning it counterclockwise.  
2. Insert two “AA” batteries (not included) into the battery compartment,  
observing the polarity markings on the flashlight case. Please see picture.  
3. Replace the battery compartment cap, and secure it by turning clockwise until  
hand tight.  
SKU 92061 DowFnlooardtferocmhWniwcwa.lSqomuaensutailos.ncosm,.pAllel MaasneuaclsaSlle1a-rc8h0A0n-d44D4ow-3nl3o5ad3. Page 4  
Select and install the desired lense.  
1. The lenses are stored in a compartment at the bottom of the flashlight, under  
the compass. Open this compartment by turning the cap counterclockwise.  
2. Select the desired lense. NOTE:Your preference may vary, but suggested  
lens application is: RED for very low light output, GREEN for low light output,  
YELLOW for contrast in haze or fog, FROSTED for diffused light.  
3. To change or install the lense, remove the  
lense cover by turning counterclockwise.  
Replace the existing lense with the desired  
lense. Replace the lense cover, and tighten by  
turning clockwise until finger tight.  
To operate the flashlight:  
1. To turn on the flashlight, press the upper  
part of the ON /OFF switch down.  
2. To turn off the flash light, press the lower  
part of the ON / OFF switch down.  
3. To manually blink the flashlight, press the round “blink” button and release.  
Maintenance  
1. When not in use, turn OFF the flashlight to save the  
batteries.  
2. If the flashlight will not be used for several months,  
remove the batteries before storage to prevent  
possible damage caused by leaking batteries.  
“blink” button  
ON / OFF switch  
SKU 92061 DowFnlooardtferocmhWniwcwa.lSqomuaensutailos.ncosm,.pAllel MaasneuaclsaSlle1a-rc8h0A0n-d44D4ow-3nl3o5ad3. Page 5  
3.  
In case the bulb burns out, a  
spare battery is stored in a container at  
the bottom of the flashlight. Remove the  
battery by turning the storage container  
counterclockwise.  
4.  
Remove the Lantern Head by  
turning it counterclockwise. Please refer  
to the photo at left. Remove the Bulb  
Holder from the Lantern Head by turning  
it counterclockwise.  
6. Remove the old bulb from the Bulb  
Holder by pulling it straight out.  
Place the new bulb in the Bulb  
Holder, and replace the Bulb Holder  
in the Lantern Head. Secure by  
turning the Bulb Holder clockwise  
until finger tight.  
7. Replace the Lantern Head in the  
Flashlight. Turn clockwise until finger  
tight. Do not overtighten, as this  
might damage the rubber seal.  
Using the compass.  
1.  
Invert the flashlight, holding the compass  
upright. Wait a moment while the compass stops  
moving.  
2.  
The compass will orient itself to the  
magnetic directions. N toward the North, S toward  
the South, etc.  
3.  
There are many uses for a compass. For  
example by taking bearings as you move away  
from a starting point, you may be able to find your  
way back by reversing those directions on the  
return trip. Or you can find landmarks on a map  
by orienting yourself with the compass.  
SKU 92061 DowFnlooardtferocmhWniwcwa.lSqomuaensutailos.ncosm,.pAllel MaasneuaclsaSlle1a-rc8h0A0n-d44D4ow-3nl3o5ad3. Page 6  

Graco Baby Playpen Baby Playpen User Manual
Haier Washer Dryer HWM55 23BS User Manual
Hamilton Beach Coffeemaker 840107700 User Manual
Harbor Freight Tools Thermometer 96451 User Manual
Harman Kardon Trash Compactor TC 30 User Manual
Honeywell Switch Switches and Sensors User Manual
Hotpoint Microwave Oven KSO53CX S User Manual
Hotpoint Refrigerator HTN17BBT User Manual
HP Hewlett Packard Switch Q11 2510 24 User Manual
Hyundai Portable Radio H 1411 User Manual