iHome Portable Speaker IP56 User Manual

Model iP56  
Portable Stereo Speakers for  
your iPod / iPhone ®  
 
Table of Contents  
iP56 Quick Start  
1
2
Controls and Indicators  
Using the iP56  
3-4  
5
A Consumer Guide to Product Safety  
Trouble Shooting  
6
Warranty Information  
7
This product bears the selective sorting symbol for waste electrical and electronic equipment  
(WEEE).  
This means that this product must be handled pursuant to European Directive 2002/96/EC in order  
to be recycled or dismantled to minimize its impact on the environment.  
For further information, please contact your local or regional authorities.  
Electronic products not included in the selective sorting process are potentially dangerous for the  
environment and human health due to the presence of hazardous substances.  
and  
are registered trademarks of SRS Labs, Inc.  
TruBass and WOW technologies are incorporated under license from SRS Labs, Inc.  
 
Maintenance  
• Place the unit on a level surface away from sources of direct sunlight or excessive heat.  
• Protect your furniture when placing your unit on a natural wood and lacquered finish. A cloth or other protective material  
should be placed between it and the furniture.  
• Clean your unit with a soft cloth moistened only with mild soap and water. Stronger cleaning agents, such as Benzene,  
thinner or similar materials can damage the surface of the unit.  
 
Controls and Indicators  
Front Panel  
Battery Indication  
Power Button  
SRS Button  
Speakers  
Volume Down Button  
Volume Up Button  
Retractable Dock  
Rear Panel  
Fold out stand  
Fold out stand  
Line-in Jack  
AC Adaptor Jack  
Reset Button  
 
2
Using the iP56  
Charging & Playing iPhone and iPod  
The iP56 has a retracting dock to play and charge your iPhone or iPod while connected  
to AC power (it will ALSO charge when operating on the internal rechargeable battery  
and iP56 is powered on). The dock will charge your iPhone or iPod until completely  
charged then stop charging.  
1. Make sure the unit is connected to a working power source (AC adaptor is connected  
or internal battery is charged).  
2. Press on the iHome name below the dock to release and access the dock (press  
back into unit when not in use).  
3. Gently press your iPhone or iPod onto the dock. Do not force or use undue pressure.  
Make sure your iPhone or iPod is not in a case or “skin”.  
Dock Release  
4. Press the  
iPhone or iPod in play mode. Press the  
Button located on top of the iP56 to turn the unit on. Place your  
or Buttons located on top of the  
unit to adjust the system volume. Press the SRS™ Button for enhanced bass  
response.  
Note: Docking an already playing iPhone or iPod will also turn the iP56 on.  
RESET  
R E S E T  
TESTT E S T  
aux-in  
Charging the Internal Battery  
The iP56 has an internal rechargeable lithium ion battery. The battery condition indicator  
is located on top of the unit. When fully charged, the indictor will glow steadily. When  
the battery needs charging, the indicator will flash. To charge, connect the iP56 to a working AC outlet.  
End-Of-Life Battery Disposal Instructions  
The iP56 uses an internal Lithium-ion battery that may be recharged hundreds of times and should last the lifetime of the  
device. The rechargeable battery is also recyclable. The battery is permanently sealed inside the unit and is not consumer  
for repair information. DO NOT attempt to replace the battery yourself. If you decide that you do not want to have your unit  
repaired, please do not dispose of the unit with your normal household trash. Contact your local recycling center for information  
on the proper disposal of products containing rechargeable batteries. In addition, many electronics stores, possibly including  
the store where you purchased your unit, are now accepting used electronics products containing recyclable batteries and  
other hazardous materials, for proper disposal and/or recycling.  
Caution: The Battery used in this device may present a risk of fire, explosion or chemical burn if mistreated  
Battery shall not be exposed to excessive heat such as fire, or the like. Do not use or charge the battery if it appears to be  
leaking, discolored, deformed, or in any way abnormal. Do not leave your battery discharged or unused for extended periods  
of time. When batteries are misused, they may explode or leak, causing burns and personal injury. If your battery leaks, use  
normal precaution and cease using the product right away.  
3
 
Using the iP56  
Using the Aux Line-in Jack  
The iP56 has an aux line-in jack located on the back of the unit to play other audio devices.  
1. Connect one end of a standard 3.5mm audio cable (available at www.ihomeaudio.com) to the aux line-in jack and the  
other end into the headphone or line-out jack on your audio device.  
2. Press the  
Button on the iP56 to turn it on. Make sure your device is turned on, too.  
3. Put your device into play mode. Press the  
volume on your device, too.  
or  
Buttons to adjust the system volume. You may need to adjust the  
4.Press the  
Button to turn the iP56 off. Remember to turn your device off, too.  
Note: Do not play an audio device through the aux line-in jack while an iPhone or iPod is playing in the dock or you will hear  
both at once.  
Resetting the iP56  
Your iP56 was designed with a special surge protection circuit to prevent permanent damage to the  
unit in the event of an unexpected power surge. If your unit appears to be ‘locked up’ and is not  
operating normally, and you know that the battery is properly charged, use a straightened paper clip,  
toothpick, or similar object to press the RESET button, located on the back panel next to the AC  
jack. This will unlock the unit and restore the original factory default settings.  
Reset button located  
on back of unit  
4
 
A Consumer Guide to Product Safety  
When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However,  
improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully  
before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in  
these instructions and on the unit.  
1. Water and Moisture – The unit should not be used near water. For example: near a bathtub, washbowl, kitchen sink,  
laundry tub, swimming pool or in a wet basement.  
2. Ventilation – The unit should be situated so that its location or position does not interfere with its proper ventilation. For  
example, it should not be situated on a bed, sofa, rug or similar surface that may block ventilation openings. Also, it  
should not be placed in a built-in installation, such as a bookcase or cabinet, which may impede the flow of air through  
the ventilation openings.  
3. Heat – The unit should be situated away from heat sources such as radiators, heat registers, stoves or other appliances  
(including amplifiers) that produce heat.  
4. Power Sources – The unit should be connected to a power supply only of the type described in the operating instructions  
or as marked on the appliance.  
5. Power-Cable Protection – Power supply cables should be routed so that they are not likely to be walked on or pinched  
by items placed upon or against them. It is always best to have a clear area from where the cable exits the unit to where  
it is plugged into an AC socket.  
6. Cleaning – The unit should be cleaned only as recommended. See the Maintenance section of this manual for cleaning  
instructions.  
7. Objects and Liquid Entry – Care should be taken so that objects do not fall and liquids are not spilled into any openings  
or vents located on the product.  
8. Attachments – Do not use attachments not recommended by the product manufacturer.  
9. Lightning and Power Surge Protection – Unplug the unit from the wall socket and disconnect the antenna or cable  
system during a lightning storm or when it is left unattended and unused for long periods of time. This will prevent damage  
to the product due to lightning and power-line surges.  
10. Overloading – Do not overload wall sockets, extension cords, or integral convenience receptacles as this can result in  
a risk of fire or electric shock.  
11. Damage Requiring Service – The unit should be serviced by qualified service personnel when:  
A. the power supply cable or plug has been damaged.  
B. objects have fallen into or liquid has been spilled into the enclosure.  
C. the unit has been exposed to rain.  
D. the unit has been dropped or the enclosure damaged.  
E. the unit exhibits a marked change in performance or does not operate normally.  
12. Periods of Nonuse – If the unit is to be left unused for an extended period of time, such as a month or longer, the power  
cable should be unplugged from the unit to prevent damage or corrosion.  
13. Servicing – The user should not attempt to service the unit beyond those methods described in the users operating  
instructions. Service methods not covered in the operating instructions should be referred to qualified service personnel.  
5
 
Trouble Shooting  
Symptom  
Possible Problem  
Solution  
Unit doesn’t respond  
(no power)  
AC adaptor isn’t plugged into a wall outlet  
or the connector is not plugged into the  
power supply jack on the back of the dock  
Plug the AC adaptor into a wall outlet and plug the  
connector into the supply jack on the unit  
Plug another device into the same outlet to confirm the outlet  
is working. Make sure any associated power switch is ON  
Wall outlet is not functioning or switched off  
Battery is weak/ dead  
Charge internal battery by connecting AC adaptor to  
working outlet until battery indicator glows steadily.  
iPod/iPhone does not  
dock properly  
iPod/iPhone not docked properly  
Remove your iPod/iPhone from the dock and check for  
obstruction on the connectors in the dock and on your  
iPod/iPhone. Make sure there is no “skin” or case on the  
iPod/iPhone. Then reseat it in the dock.  
iPod/iPhone does  
not respond to the  
unit  
Remove your iPod/iPhone from the dock and check for  
obstruction on the connectors in the dock and on your  
iPod. Then reseat it in the dock.  
iPod/iPhone is not docked properly  
Upgrade software on your iPod/iPhone via iTunes  
Your iPod/iPhone software is too old  
iPod/iPhone is locked up  
Please make sure your iPod/iPhone is working properly  
before docking into the unit. Please refer to your  
iPod/iPhone manual for details.  
Using 1st or 2nd generation iPod, iPod  
shuffle or other devices.  
Unit cannot control those iPod models or other devices.  
Use the Line-in jack to play these devices.  
iPod/iPhone does not  
come on immediately  
If your iPod/iPhone is not used for some  
time, it may enter deep sleep mode  
Press the Menu button on your iPod/iPhone  
Charge your iPod/iPhone for about 5 minutes  
iPod/iPhone battery is run down or is too  
weak  
Insert the end of a paperclip or similiar into the Reset port  
located next to the AC jack and press in for a few seconds  
to restore the unit to factory default settings. Doing so will  
overwrite any current settings.  
Unit operation is erratic  
Unit requires reset  
6
 
iP56-032610-A  
Printed in China  
 

Graco Car Seat PD238270A User Manual
Grizzly Lathe G9972Z User Manual
Grundig Home Theater System AVR 5200 DD User Manual
Harbor Freight Tools Sander 2485 User Manual
Healthrider Home Gym HREX04981 User Manual
Honeywell Clock PRC507W User Manual
Honeywell Scanner MS9520 User Manual
Honeywell Security Camera HD4D User Manual
Husqvarna Lawn Mower 46 RC User Manual
Husqvarna Trimmer 240R User Manual