eLecTrIc FIrePLace
ManTeL
ManTeauX de cheMInÉe
ÉLecTrIQues
rePIsas Para
chIMenea eLÉcTrIcas
Assembly Instructions
Instructions d'assemblage
Instrucciones de montaje
W
À
S
YEAR
ANNÉE
AÑO
1
MEF2808CHG
save These InsTrucTIons
conserver ces InsTrucTIons
guarde esTas InsTruccIones
REV00
Get Ready to start
Before assembly, use scissors to unwrap the parts from the packaging. Do noT use a box cutter or exacto-knife
as you may cut into the mantel pieces inside the box and damage the finish. Check for the hardware bag which is
RED and located inside the packaging, taped to the top box. Be sure you Do noT discard any pieces.
Tips FoR THE AssEMbly oF youR nEw MAnTEl
step 1
step 1
• Before you begin assembly, locate the instructions and hardware. Take out all the parts and
compare them to the diagrams below. Be sure you have all the parts and can identify them.
Locate the base and place it on the floor. Do not put it up against the wall at this
point in the assembly, as you need to get in behind the mantel to insert several
wingnuts, lock washers and firebox screws.
• A helping hand is always good. Assemble your mantel with an adult assistant if possible. Some pieces are heavy
and will need to be held by a helper. Assembly time will take approximately 30-60 minutes.
step 2
step 2
Locate the left side panel and the left front panel. Facing the front of the base,
take the left side panel, positioning it so the holes in the blocks on the bottom
line up with the holes on the base. Position the left front panel next to the left side
panel, lining up the holes in the blocks with the holes on the base. Attach the left
front and side panel to the base by inserting and tightening 1 wingnut and 1 lock
washer to each piece. Attach the left side and front panels together by inserting
and tightening 2 wingnuts and 2 lock washers.
OUTSiDE
ViEW
inSiDE
ViEW
TOP 1PC
CHERRY: ZZ.2808CHG.08
step 3
Repeat Step 2, but with the right side panel and the right front panel.
BASE 1PC
CHERRY: ZZ.2808CHG.01
step 4
step 4
LEFT FROnT
RiGHT FROnT
LEFT SiDE
RiGHT SiDE
PAnEL 1PC
PAnEL 1PC
CHERRY:
PAnEL 1PC
CHERRY:
PAnEL 1PC
Locate the lower facing panel and
the firebox shelf. Attach the lower facing
panel by placing the finished side to the
front then line up the holes on each side
and insert 1 wingnut and 1 lock washer
into each. Place the firebox shelf in
behind, right up against the lower
facing panel.
CHERRY:
CHERRY:
ZZ.2808CHG.05
ZZ.2808CHG.04
ZZ.2808CHG.03
ZZ.2808CHG.02
UPPER FACinG PAnEL 1PC
CHERRY: ZZ.2808CHG.06
FiREBOX SHELF 1PC
CHERRY: ZZ.2808CHG.09
LOWER FACinG PAnEL 1PC
CHERRY: ZZ.2808CHG.07
step 5
step 5
Locate the upper facing panel that will be attached to the left and right legs and
will sit above the firebox. Position this panel with the finished side facing the front
of the mantel. Line up the holes on each side and insert and tighten 1 wingnut and
1 lock washer on each side.
17PCS
17PCS
2PCS
2PCS
4PCS
4PCS
4PCS
WinGnUT AnD LOCK WASHER
AnTi-TiP DEViCE 2 SETS
1
2
step 6
step 6
wARRAnTy
Greenway Home Products is pleased to offer in-home warranty repairs. Please refer to your Firebox Use and Care Guide for warranty
information on your Firebox.
Get your assistant and locate the top of your mantel. This top is very heavy. It
will take 2 people to lift and position it in place. Ensure the top goes over the
positioning guide located on the header. The top must go over this guide to be
positioned correctly. Line up the holes on the top of the mantel, insert and tighten
5 wing nuts and lock washers.
Do noT RETuRn THis pRoDuCT To THE sToRE:
Please contact Customer Service at: 1-866-253-0447
Monday to Thursday from 8:30AM to 5:00PM (EST), Friday from 8:30AM to 4:00PM (EST)
Web: www.greenwayhp.com
Email: support@greenwayhp.com
Canada:
usA:
400 Southgate Dr., Guelph, Ontario, Canada, N1G 4P5
6507 Fairfield Dr., Northwood,Ohio, USA, 43619
step 7
limited warranty Definitions:
Greenway Home Products:
Take your electric firebox out of its packaging and position it between the 2 legs
of the mantel. Once you are close to the wall, plug the firebox into the nearest
outlet.
(Greenway)
Mantel:
Manufacturer.
Mantel manufactured by Greenway Home Products.
Purchaser:
Distributor:
Warranty Card
Purchaser of the Mantel
Facility authorized to sell Greenway Home Products.
Greenway Home Products Limited Warranty Registration Card identifying the Purchaser and product model.
The firebox comes with 3 metal brackets and 20 black screws. These metal
brackets must be attached to both the sides of the firebox and the mantel to
ensure that your firebox does not move around as you use it. 2 of the brackets
have 2 large holes on one side. These large holes line up with 2 screws on the
side of the firebox. The other screws provided must be inserted into the holes at
the other end of the bracket and into the firebox. The other side of each bracket
attaches to the mantel.
Greenway limited warranty:
Greenway warrants to the Purchaser that the Mantel is free from defects in material and workmanship, under normal use and service,
for 1 year (1 year limited parts) from the date of purchase.
All warranty repairs must be preauthorized by Greenway Home Products. Greenway will, at its’ option, replace or repair free of charge
any defective part, which the Purchaser shall notify their Distributor or Greenway Home Products within the warranty period. The
obligation of Greenway Home Products under this warranty, is expressly limited to such replacement or repairs.
The provisions of this limited warranty shall not apply to the following:
1. Accidents.
2. Unauthorized repairs or alterations.
The 3rd bracket has no holes on 1 side. That side should go up against the
firebox top but should not be attached as the heater sits right underneath the
bracket. Only the mantel side should be attached.
3. Normal maintenance.
4. Changes made to other units manufactured after this mantel was manufactured.
5. Incidental damages caused by failure of the mantel such as inconvenience or loss of use.
6. Improper installation.
If you have any questions about the firebox please reference the installation
instructions that come with the firebox. Please reference the Quick Tips section
of that instruction manual.
The provisions of this limited warranty shall not apply to deterioration due to wear and exposure beyond the following limitations:
1. For 180 days from the date of purchase for exterior finished surfaces.
Due to the properties of natural wood, Greenway Home Products makes no warranty against mineraling of wood components.
Greenway limited warranty is void unless the following conditions are adhered to:
step 8
You are now ready to position your mantel against the wall. This step requires 2
people to move the unit.
1. Warranty registration must be completed and returned to a Greenway Home Products.
2. All warranty repairs must be preauthorized by a Greenway repair facility.
3. Greenway reserves the right to inspect defective parts that have been replaced under warranty. Dealer is expected to hold
defective parts for 60 days.
4. Only parts and accessories and other material, available through Greenway Home Products are to be used in the performance
of warranty service.
5. Purchasers are responsible for presenting/notifying their Distributor as soon a problem exists. The warranty repairs should be
completed in a reasonable amount of time from the date of authorization. Not to exceed 30 days past notification.
Anti-tipping device
At this point you must attach the anti-tipping device to your mantel and your wall.
This device is a safety feature that will prevent your mantel from tipping over if a
weight is applied which can unbalance the unit.
This limited warranty is expressly in lieu of any other expressed or implied warranty, including any implied warranty or merchantability
or fitness for a particular purpose and of any obligations or liabilities on Greenway Home Products which neither assumes nor
authorizes any other person to assume for it any other liability in connection with the Mantel
manufactured by it.
The warranty is null and void if used in commercial or industrial applications.
3
4
|